RV191 (Astrometric/Geodetic VLBA-191) 2026 Nov. 11 18:00 UTC DOY 315 Notes prepared by David Gordon (USNO) (david.gordon126.civ@us.navy.mil) Special notes for this session: =============================== This session will use the RDBE/DDC/Mark6 system at the VLBA sites, as in previous RV sessions. The X-band frequencies are: 8365.75, 8445.75, 8805.75 and 8925.75 MHz, and spans 560 MHz. The S-band frequencies are: 2212.75, 2242.75, 2282.75 and 2372.75 MHz. The ending in .75 MHz is necessary at the VLBA stations. Therefore it will not be possible to monitor phase cals using the 10 kHz filters. RV191 will record 8 16-MHz bandwidth channels using 2-bit sampling. The bit rate will be 512 Mbits/sec. The data will be correlated at the VLBA using the VLBA DiFX software correlator. There are 3 non-VLBA legacy stations scheduled - HARTRAO, ONSALA60, and WETTZELL. The non-VLBA stations should see the "Special operations notes for non-VLBA stations" section below for special instructions. The schedule begins at 18:00 UTC on DOY 315(2026 Nov 11). The first scheduled scan at each station is: Br-Fd-Hn-Kp-La-Nl-On-Ov-Pt-Sc: 1846+322 @ 2026/315-18:00:00 UTC Hh: 2037+216 2026/315-18:01:55 UTC Wz: 2318+049 2026/315-18:45:08 UTC Mk: 0834+250 2026/315-18:47:07 UTC To facilitate fringe-finding, there are some long scans on fairly strong sources with many antennas during the schedule. All stations please try to be onsource and recording data for these scans. These scans are: Source Start DURATIONS name yyddd-hhmmss Br Fd Hh Hn Kp La Mk Nl On Ov Pt Sc Wz 1803+784 26315-184929| 307 319 300 323 320 300 311 320 315 321 300 323| 1936-155 26315-185621| 300 300 373 300 300 374 319 300 367 374| 1053+704 26316-055316| 300 300 300 300 300 300 300 300 300 300| 0605-085 26316-060923| 399 399 300 390 300 398 395 369 300 399 378 399| 0834+250 26316-162339| 373 387 379 386 383 480 380 480 384 | We are again using the 'Fill' scheduling option. 'Fill' is run after a schedule is finished in the normal manner. It increases the scan times at stations, when possible, based on how much idle time each station has before its next scan. We used a 'FILL_OFF' margin of 5 seconds. Using 'Fill' on the original schedule, the average observing time increases from 53% to 64%, the average idle time decreases from 23% to 11% and the average observation time increases from 118 seconds to 144 seconds. Antab files and antenna gains requested ====================================== Sources in this session will also be imaged. We request that the non-VLBA stations create antab files of system temperatures if at all possible. Please Email these antab files, along with antenna gain information to david.gordon126.civ@us.navy.mil and christopher.n.dilullo.ctr@us.navy.mil. Purpose ======= This is the eleventh of 12 coordinated astrometric/geodetic sessions in 2026 that use the full 10-station VLBA plus several IVS stations capable of recording VLBA modes. This year's series is a continuation of the highly successful RDV series begun in 1997. These are now being run under the USNO's VLBA time allocation. For 2026, these sessions will concentrate on observing and imaging ICRF3 sources that show small offsets from Gaia positions. Schedule information ==================== This is a new schedule generated by David Gordon at USNO using sked. Schedule file name: rv191.skd. At the IVS Data Center (https://cddis.nasa.gov/archive/vlbi/ivsdata/aux/2026/rv191/ Sked file: rv191.skd Text file: rv191.txt At the VLBA/NRAO: Sked file: rv191.skd Vex file: rv191.vex Text file: rv191.txt Summary file: rv191.sksum This session uses the 10 VLBA stations and 3 IVS stations. The IVS stations are: HARTRAO, ONSALA60, and WETTZELL. Below is the sked summary. Key: Br=BR-VLBA Fd=FD-VLBA Hh=HARTRAO Hn=HN-VLBA Kp=KP-VLBA La=LA-VLBA Mk=MK-VLBA Nl=NL-VLBA On=ONSALA60 Ov=OV-VLBA Pt=PIETOWN Sc=SC-VLBA Wz=WETTZELL Br Fd Hh Hn Kp La Mk Nl On Ov Pt Sc Wz Avg % obs. time: 66 66 59 65 66 67 49 68 68 64 67 64 70 64 % cal. time: 4 5 2 4 5 5 3 4 3 5 5 4 3 4 % slew time: 21 22 32 22 22 21 17 21 11 21 22 22 6 20 % idle time: 7 6 6 8 5 6 30 6 17 9 5 10 20 11 total # scans: 388 426 202 355 447 431 294 384 218 416 438 338 245 352 # scans/hour : 16 18 8 15 19 18 12 16 9 17 18 14 10 15 Avg scan (sec): 147 134 251 158 128 134 143 153 271 134 132 163 247 168 # data tracks: 16 16 16 16 16 16 16 16 16 16 16 16 16 # Mk5 tracks: 16 16 16 16 16 16 16 16 16 16 16 16 16 Total TB(M5): 3.65 3.64 3.24 3.60 3.65 3.71 2.69 3.76 3.78 3.56 3.69 3.52 3.87 3.57 # OF OBSERVATIONS BY BASELINE | Br Fd Hh Hn Kp La Mk Nl On Ov Pt Sc Wz Total --------------------------------------------------------------------------- Br| 282 19 182 305 300 231 236 33 338 304 160 38 2428 Fd| 30 225 391 403 184 301 44 305 407 221 46 2839 Hh| 82 18 30 0 46 188 8 25 79 193 718 Hn| 198 225 87 280 92 162 217 283 112 2145 Kp| 391 227 272 33 358 414 191 36 2834 La| 185 309 45 317 415 220 52 2892 Mk| 127 9 271 198 84 11 1614 Nl| 62 225 293 273 73 2497 On| 25 40 81 196 848 Ov| 327 154 22 2512 Pt| 212 45 2897 Sc| 105 2063 Wz| 929 Number of 2-station scans: 0 Number of 3-station scans: 240 Number of 4-station scans: 83 Number of 5-station scans: 68 Number of 6-station scans: 75 Number of 7-station scans: 107 Number of 8-station scans: 60 Number of 9-station scans: 65 Number of 10-station scans: 72 Number of 11-station scans: 10 Number of 12-station scans: 8 Number of 13-station scans: 0 Total number of scans: 788 Total number of obs: 13608 Average obs-time: 144.4 INTENSIVE BREAKS ================ MK-VLBA and WETTZELL will be observing the I26315 session at start time and will join in after 18:45 UTC. They will also drop out ~45 minutes before the end of rv191 to observe the I26316 session. SOURCE SELECTION ================ 80 sources were selected for this session. 77 are from a list of 920 ICRF3 sources that have small ICRF3/Gaia offsets. These are being observed for possible use as alignment sources between Gaia and the ICRF. SCHEDULING ALGORITHMS ===================== This schedule uses the "SRCEVN SQRT" mode of Sked. In the absence of any constraints, Sked will preferentially observe strong sources that have high visibility. This mode attempts to smooth out the number of observations per source. RECORDING MODE and FREQUENCIES ============================== The data will be recorded using the following setup: 8 channels, each 16 Mhz bandwidth 1:2 fan-out 32 MHz sample rate 2-bit sampling This recording mode is a modified version of 512-16(RDV). There is no correlator speed-up factor. The frequency sequence covers 560 MHz at X-band and 160 MHz at S-band using 4 channels in each band. At the VLBA, the X-band uses two LO's in order to fit into the VLBA 512 MHz passband. At the non-VLBA stations, the X-band uses both the high and low parts of the geodetic receivers. Because only 8 channels are available when observing with the VLBA/RDBE/DDC systems, wider spanned bandwidths are not advisable. The following tables list the setups for the VLBA stations and the geodetic stations with DBBC, Mark IV, Mark 5, and VLBA5 back ends. These setups represent our best knowledge. If there are errors, please let us know. VLBA | HARTRAO Chan Sky Tracks LO IF BBC | LO IF BBC BBC# 1 X 8365.75 2, 4, 6, 8 7600 B 765.75| 8080.0 A1 285.75 3 2 X 8445.75 10,12,14,16 7600 B 845.75| 8080.0 A1 365.75 4 3 X 8805.75 18,20,22,24 9600 D 794.25| 8080.0 B2 725.75 5 4 X 8925.75 26,28,30,32 9600 D 674.25| 8080.0 B2 845.75 6 5 S 2212.75 3, 5, 7, 9 3100 A 887.25| 2020.0 C1 192.75 9 6 S 2242.75 11,13,15,17 3100 A 857.25| 2020.0 C1 222.75 10 7 S 2282.75 19,21,23,25 3100 A 817.25| 2020.0 C1 262.75 13 8 S 2372.75 27,29,31,33 3100 A 727.25| 2020.0 C1 352.75 14 VLBA | ONSALA60, WETTZELL Chan Sky Tracks LO IF BBC | LO IF BBC BBC# 1 X 8365.75 2, 4, 6, 8 7600 B 765.75| 8080.0 A1 285.75 3 2 X 8445.75 10,12,14,16 7600 B 845.75| 8080.0 A1 365.75 4 3 X 8805.75 18,20,22,24 9600 D 794.25| 8080.0 B1 725.75 5 4 X 8925.75 26,28,30,32 9600 D 674.25| 8080.0 B1 845.75 6 5 S 2212.75 3, 5, 7, 9 3100 A 887.25| 2020.0 C1 192.75 9 6 S 2242.75 11,13,15,17 3100 A 857.25| 2020.0 C1 222.75 10 7 S 2282.75 19,21,23,25 3100 A 817.25| 2020.0 D1 262.75 13 8 S 2372.75 27,29,31,33 3100 A 727.25| 2020.0 D1 352.75 14 Special operations for non-VLBA stations: ========================================= All non-VLBA stations: Please note that due to the frequency sequence, phase-cal will not be visible with a 10 kHz viewing filter in the USB channels. If you have another means to verify phase-cal, please use it. If you have a Mark IV Decoder, please contact Ed.Himwich@nasa.gov if you would like advice on how to set it up to check phase-cal for this frequency sequence. Please check the procedures created by drudg. If you find errors, please correct it and let us know so we can correct the catalog. CHECKLIST for non-VLBA stations =============================== Please follow the checklist below to ensure you have done all the necessary steps for this session: 1. Make .prc file with DRUDG and check them out, or use the procedures from the last RV session. Check out parity check procedures. 2. Make the .snp file with DRUDG. 3. Set up your system to monitor the clocks with the "gps-fmout" or "fmout-gps" commands. If you have questions about this, please contact Ed Himwich as soon as possible. 4. Send a "ready" message an hour or so before the session to the ivs-ops mail list (ivs-ops@lists.nasa.gov). Copy analysts@nrao.edu and vlbiobs@nrao.edu on your ready message. 5. Send a "start" message soon after you have started recording. Copy analysts@nrao.edu and vlbiobs@nrao.edu on the message. 6. At the end of the session, send a "finish" message summarizing how the session was conducted. Copy analysts@nrao.edu and vlbiobs@nrao.edu on your message. 7. Transfer your log file to your normal IVS data center. E-transfer of data to Socorro ============================= This session will be correlated in Socorro on the NRAO/VLBA DiFX software correlator. NRAO has recently developed an E-transfer system and can now accept direct E-transfers of data from the stations to Socorro. Please E-transfer your data to NRAO/Socorro using etc/etd if at all possible. Contact Anthony Sowinski (asowinsk@nrao.edu) for instructions. However, if you are not able to transfer by this method, you will need to transfer your data to Haystack, as before. Contact Jason Soohoo (jsoohoo@mit.edu) for E-transfers to Haystack.