Starting generation of Calibration File 
FS version = 0009.0011.0019 
time_zero = 11988000 
Found #4 errors of type = ERROR fl   -1 Previous source in this schedule not reached before new source was commanded 
Found #3 errors of type = ERROR qk -211 Tsys value for device 1u overflowed or was less than zero. 
Found #3 errors of type = ERROR st   -7 Antenna off-source! 
Found #3 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #3 errors of type = ERROR an -103 Pointing computer tracking errors are too large. 
Found #2 errors of type = ERROR qk -211 Tsys value for device 1l overflowed or was less than zero. 
Found #2 errors of type = ERROR an   -7 Antenna communications restored. 
Found #2 errors of type = ERROR st   -2 Antenna timed out. 
Found #1 errors of type = ERROR st   -4 Interface not set to remote. 
Found #1 errors of type = ERROR qk -211 Tsys value for device 2u overflowed or was less than zero. 
Found #1 errors of type = ERROR qk -211 Tsys value for device ia overflowed or was less than zero. 
Found #1 errors of type = ERROR qk -211 Tsys value for device ic overflowed or was less than zero. 
Found #1 errors of type = ERROR 5k  302 There have not been two scan_name ... commands since the schedule started  use scan_check force to force check 
Found #1 errors of type = ERROR qk -211 Tsys value for device ib overflowed or was less than zero. 
Found #1 errors of type = ERROR st   -6 Antenna control restored. 
Found these BBCs:   
NBBC: 0
Found these SK parameters: get get get
RX1 min= 100000 max= 2017.138.18:30:04.16
RX2 min= 100000 max= -1
RX3 min= 100000 max= -1
Plotting 0 Tsys channels:   
Tsys values are: -1 1 2 etc
NTSYS: 0