Starting generation of Calibration File 
FS version = 0009.0010.0002 
time_zero = 1346400 
Found #237 errors of type = ERROR ch -371 IF3 alarm is on 
Found #76 errors of type = ERROR qk -204 No detectors selected 
Found #29 errors of type = ERROR qk -211 Tsys value for device v9 overflowed or was less than zero. 
Found #17 errors of type = ERROR qk -211 Tsys value for device i2 overflowed or was less than zero. 
Found #8 errors of type = ERROR ch -308 v8 total power integrator overflow 
Found #6 errors of type = ERROR qo -301 WARNING: ONSOURCE status is SLEWING! 
Found #1 errors of type = ERROR bo -133 Error opening procedure library 
Found these BBCs: vc02 vc06 vc11
NBBC: 3
Found these RX parameters: 00(FRONT) 01(REAR) 02(LO)
RX1 min= -10.31 max= 2009.015.15:44:20.01
RX2 min= -2.381 max= 22.65
RX3 min= 5.800 max= 29.60
Plotting 3 Tsys channels: 02 06 11
Tsys values are: 3 4 -1 etc
NTSYS: 3
in match_chan ft1=  nt1=  st1=  tt= 
set scale tsys1 [2] min max 49.4 305
set scale tsys2 [2] min max  
set scale tsys3 [2] min max  
set scale tsys4 [2] min max  
 Tsys scale ymin -5 ymax 5